Accessory Sockets - Aston Martin Vantage S 2016 Owner's Manual

To Install
Insert the boot cover, from below, and locate the two rear pins. Raise
the cover. Locate the two side pins up into the area provided in the
trim panel. Slightly push forward and allow to drop into position.
Install the two boot lid cords.
3.30

Accessory Sockets

Warning: Damage to electrical circuits will result if more than
10 amps is drawn from the accessory socket. Only connect
accessories which are designed for use in a motor vehicle.
Foreign items can get into the socket and cause damage -
always place the cover on the accessory socket when not in use.
Extended use of an accessory socket when vehicle engine is set
to OFF will discharge the battery.
Read the manufacturer's instructions and make sure that you do not
connect any device which would exceed current rating of the
accessory socket.
Vehicles installed with the non-smoking kit have a third accessory
socket provided in the trinket box.
Accessory sockets are mounted in the armrest storage box or tray and
the boot right side wall (A and B) and may be used to power any
12 volt vehicle accessory requiring a current of less than 10 amps.
[A] : Coupe
[B] : Roadster
Roadster Only: An accessory socket
is mounted in the rear storage tray.