Continuous Power Connection; Data Cable Installation - Motorola iM1000 User Manual

Antenna
iM1000
Figure 5. Switched Power Connection
Perform the following steps to install the iM1000 modem in the vehicle.
1. Prepare a routing plan for the ignition cable after determining where
the iM1000 is to be mounted.
2. Connect the free end of the ignition cable to the vehicle ignition
switch, and the other end (with the plug) to the iM1000 ignition
connector.

Continuous Power Connection

A power on plug is permanently plugged into the ignition connector. When
the power is supplied to the iM1000 DC Power connector, the modem turns
ON.
Antenna
iM1000
Figure 6. Continuous Power Connection

Data Cable Installation

Connect one side of the 9-pin cable (FKN4369A) to the iM1000
communication connector and the other side to the DTE. Since the iM1000
is a modem, it can be connected only to the DTE equipment, using a 9-pin
to 9-pin cable.
Hardware Installation
Pwr Cable FKN4878A
PWR
IGN
Ignition Cable
FKN4868A
FKN4878A
PWR
IGN
Vehicle
Battery
Car
Switch
Power Source
Power On Plug
FLN9400A
9