Table of Contents
Advertisement
4. Advanced Printing
• If you use Outline mode for letter images with a thickness of less than 3mm (0.12 inches) the print
image might come out as expected.
• The image might differ depending on how the designated area is drawn, so remember the
following when making the command sheet.
Designated area
Part of the designated area
is surrounded by 3 sides of
the entire area.
Double line pattern.
The designated area is
surrounded by 3 sides of
another designated area.
Non-closed line
114
Area recognized
Make a space of at least 2mm (0.08 inches),
in front of the area surrounded by 3 sides
(relative to the feed direction).
1
1, 2 = 2mm (0.08 inches)
Only the outer line
Make a gap of at least 2mm (0.08 inches) in
is recognized.
width.
Make a space of at least 2mm (0.08 inches)
in front of the area surrounded by 3 sides
(relative to the feeding direction).
1
1, 2 = 2mm (0.08 inches)
Designate the area with a closed line.
Preferred designated area
2
2
Advertisement
Table of Contents
