Table of Contents
Advertisement
www.ti.com
2
Quick Setup Guide
Many of the components on the LP8755 are susceptible to damage by electrostatic discharge (ESD).
Customers are advised to observe proper ESD handling precautions when unpacking and handling the
EVM, including the use of a grounded wrist strap at an approved ESD workstation.
On opening the LP8755EVM package, ensure that the following items are included:
•
LP8755 Evaluation Board
•
USB Interface Board
•
USB Cable
If any of the items are missing, contact the closest Texas Instruments Product Information Center to
inquire about a replacement.
2.1
Installing/Opening the Software
The EVM software is controlled through a graphical user interface (GUI). The software communicates with
the EVM through an available USB port. The minimum hardware requirements for the EVM software are:
•
IBM PC-compatible computer running a Microsoft Windows® XP or newer operating system
•
Available USB port
•
Mouse
The latest downloadable software is available at http://www.ti.com/tool/lp8755evm. Download the zip file
onto your local hard drive, then unzip this folder. Make sure the USB Interface Board is connected to the
Evaluation Board, and connect the USB Interface Board to the PC with the USB cable. Refer to
1. With the power supply disconnected from the unit under test (UUT), open the un-zipped folder, and
click on lp8755_nnn.exe (nnn is the version number) to start the software.
2. On the Evaluation SW window bottom right corner you should see text "USB Board connected". Refer
to
Figure
2.
SNVU290 – NOVEMBER 2013
Submit Documentation Feedback
Copyright © 2013, Texas Instruments Incorporated
Quick Setup Guide
Figure
The LP8755 Evaluation Module
1.
5
Advertisement
Table of Contents
