Leds; Led Notifications; Table 11: Status Leds - Mellanox Technologies TX6000 Hardware User Manual

Push the Resetr button and keep it pressed for up to 14 seconds.
 To reset the system, the CPU of its management board and the "admin" password, perform
the following:
Push the Reset button and keep it pressed for at least 15 seconds. You will then be able to enter
without a password and set a new password for the user "admin".
3.2

LEDs

3.2.1

LED Notifications

The system's LEDs are an important tool for hardware event notification and troubleshooting.
Mellanox systems have two types of LEDs:
• Status LEDs
• Port LEDs
The Status LEDs are located to the left side of the front panel and on the power side at the far
right. The port LEDs are located on top of the data ports- see Section 3.2.3.
Table 11 - Status LEDs
Symbol Name
Shows the health of the system
System Status LED
Fan Status LED Shows the health of the fans
Power supply #1 Shows the health of the right side power supply
unit
Power supply #2 Shows the health of the left side power supply unit Green
Bad Port LED lights up when a symbol error is detected on one
of the ports.
Unit Identifier LED Lights up on command through the CLI
Description
Mellanox Technologies
Normal Conditions
Green
Green
Green
Off
Off
30