Table of Contents
Advertisement
2.3 How to read the display
MODE
SINGLE CYCLE
Sheets/Set= 1
L=210mm BS=70%
SHEETS PER SET
LENGTH
Length: 210mm
2.4 Explanation of the menus
START
MODE
Main Menu
STOP
PAUSE
Run Mode Menu
The arrow on the left side of the display shows which
On-line
option is currently selected.
Pressing the OK button on the control panel confirms
your selection and the corresponding submenu will
appear in the display.
On the right side of the display, up and/or down arrows
appear if there are more options that can be selected.
These arrows are also displayed when the value of
the selected option can be increased/decreased using
the arrow buttons. Use the up/down buttons on the
control panel for selecting, scrolling or adjustment.
The "Main Menu" is displayed with the option "START"
1
selected when the Model F601 is switched on. The
On-line
information in the display shows that the Model F601
is ready to start, it is (in this case) on-line with the
system and the ID number in the system is one. See
table below.
Press the OK button on the control panel to confirm
00075
your selection and the Model F601 will start. If the
F601 is installed in a system with a Model F610 Inserter
and a Model F612/F615 Collator, the complete system
can be started from any unit's start button. The "Main
Menu" will be replaced with the "Run Mode Menu"
when the Model F601 system is started.
If "Module Priority" in F601 is changed to ID no.2.
*
If the power is off to the Model F612/F615, a "Comm
**
Error" is created. Turn on the power to the Model
F612/F615 and select OFF-line or ON-line.
Units in the system
Model F610 Model F601 Model F612/F615
2
ID number
3
*
3
**
1
5
The Feeder
1
not installed
1
2
2
1
2
No power
Advertisement
Table of Contents
