Pitney Bowes F601 Operating Manual page 16

6.1 General Problems (continued)
Displayed message
WARNING
Feeder is empty
System ERROR
Interlock at (X)
System ERROR
Jam at (X)
Possible causes
1. No inserts.
Reset
2. Inserts do not cover the
sensor on the insert table.
3. Insert sensor defective.
1. Interlock switch at unit
with ID number "X" is
actuated.
1. Jam at unit with ID
number "X" is sensed.
Problems?
Explanation/action
It is not registered that there are any inserts
on the insert table.
1. Reload.
2. Check that the inserts are loaded properly
(see section 3.3).
3. Run "Diagnostics" to verify status of
sensor. If the self test verifies that the sensor
is defective, have the Model F601 checked
by a qualified technician.
See section 2.4 to identify which unit is
causing the problem.
1. Check that the interlock switches are not
actuated. If problem cannot be corrected,
have the system/unit checked by a qualified
technician.
1. Clear jam at unit "X". If necessary, see
section 2.4 to identify which unit is causing
the problem.
15