Table of Contents
Advertisement
2.4 Explanation of the menus (continued)
CLEAR COUNTER
PRESET COUNTER
Option Menu
Counter
Remaining
Adjustment Menu
START
00075
MODE
On-line
On-Line
Off-Line
Off-Line
Stand Alone
MODE
On-line
SINGLE CYCLE
Sheets/Set= 1
L=210mm BS=70%
SINGLE CYCLE
CLEAR COUNTER
Clear Counter
00075
CLEAR COUNTER
PRESET COUNTER
Counter
Remaining
Scrolling down from the "Start Menu", using the arrow
buttons, you will find several options. Press the OK
button at the desired option to enter the corresponding
"Adjustment Menu" as illustrated in the figure to the
00100
left. How each adjustment menu works in detail will be
00025
described later in this text. After adjustment, press the
OK button to confirm changes or the ESC button to
cancel. In either case you will be returned to the "Option
Menus".
Decide whether the Model F601 should be on-line or
off-line with the system or function as a stand alone
unit (not applicable to Pitney Bowes models).
This menu provides information on basic settings,
number of sheets per set, insert length and belt speed.
No changes can be made here.
Clears the set counter when the OK button is pressed.
Enter the number of sets for the preset counter using
the arrow buttons. Default value is 0. This menu can
also be used to check the setting of the preset counter
00100
and the number of sets to go before the job is
00025
completed.
NOTE: When checking, use the "ESC" button to
leave the menu without changing the settings.
The Feeder
7
Advertisement
Table of Contents
