Advertisement
Available languages
Available languages
When the filter has been dismantled use the wire hook to hold up the end of the
suction line.
Be careful during fuel filter installation to prevent contamination from getting into
the suction line.
5.7. Oil filter.
Unscrew oil filler plug (18).
Use wire hook to remove the oil filter through the oil filler hole.
Wash the oil filter in petrol or replace with a new one.
Remove dirt from the tank.
Install the oil filter in the tank.
Tighten oil filler plug (18).
When putting the oil filter into the tank make sure it reaches front right corner.
5.8. Ignition plug.
To maintain reliable operation of the device, check condition of the ignition plug on
a regular basis.
Remove air filter lid (4).
Remove air filter.
Remove wire from the ignition plug.
Put on plug key (included) and unscrew the ignition plug.
Clean and adjust spacing between contacts (0.65 mm) (replace ignition plug when
necessary).
5.9. Other instructions.
Ensure there are no fuel leaks, loosened joints or damages of main parts, especially
main handle joints and guide bar fixing. When you find any damage, make sure it is
repaired before next use of the chain saw.
All faults should be repaired by service workshop authorized by the RAIDER.
Read the instructions' manual before using the machine.
On all jobs performed with the saw you must always wear safety goggles to
guard your eyes from flying materials/objects and a sound-proof helmet, earmuffs or
the like to protect your hearing. Wear a safety helmet if there is a risk of objects falling
on you from above.
Warning! Danger!
Protect yourself from saw kickback.
Hold the chain saw securely with both hands during use.
29
Advertisement
