Appendix A: Default Jumper Settings; Introduction - Xilinx VCU1287 User Manual

Default Jumper Settings

Introduction

Table A-1 lists the jumpers that must be installed on the VCU1287 board for proper
operation. These jumpers must be installed except where specifically noted in this user
guide.
Any jumper not listed in
Note:
Table A-1: Default Jumper Settings
Reference
Name
Designator
SW2.1 VCCINT
SW2.2 VCCBRAM
SW2.3 VCCAUX
SW2.4 VCCO_HP
SW2.5 VCCO_HR
J87 MGT PMBUS CTRL
J8 MGT PMBUS ISO
J121 DUT I2C
J125 SYS I2C
J24 VTT_HP SOURCE
J66 VTT_HR SOURCE
J11
J12
J13
J14
J160 UTIL_3V3_EN
SW13.1 Enable
SW13.2 ADDR0
SW13.3 ADDR1
VCU1287 Characterization Board
UG1121 (v1.0) December 11, 2015
Table A-1
Board Location
Upper Left
Upper Left
Upper Left
Upper Left
Upper Left
Upper Left
Center Right
Upper Right
Upper Right
Upper Center
Lower Left
AFX Upper-Middle
AFX Upper-Middle
AFX Upper-Middle
AFX Upper-Middle
Center-Right
Upper Right
Upper Right
Upper Right
www.xilinx.com
should be left open for normal operation.
Jumper/Dip-switch
Position
OFF
OFF
OFF
OFF
OFF
GND (2-3)
Installed
GND (2-3) DIS
PWR (1-2) EN
GND (1-2)
GND (1-2)
Installed
Installed
Installed
Installed
EN (1-2)
OFF
OFF
OFF
Appendix A
Comments
Disabled
Enabled
Red 20A jumper
Red 20A jumper
DIFF CLK 1 P
DIFF CLK 1 N
DIFF CLK 2 P
DIFF CLK 2 N
Enable SD card
configuration mode
56
Send Feedback