Table of Contents
Advertisement
Removing a CPU:
1. Before removing the CPU, turn off the M762A series power; then wait
for about 20 minutes until the heat radiation plate of the cooling fan and
the CPU cools down.
2. To remove the CPU, lift the releasing lever of the Socket 462.
Note: The CPU and the heat radiation plate are hot. They may cause
burns.
To remove the CPU, reverse the installation steps.
2.1.2
Memory Module Installation
Figure 4 display the notch marks and what they should look like on your
DIMM memory module.
DIMMs have184-pins and two notches, that will match with the onboard
DIMM socket. DIMM modules are installed by placing the chip firmly into
the socket at a 90-degree angle and pressing straight down (figure 5) until it
fits tightly into the DIMM socket.
Figure 4: DIMM Memory and 184-pins Socket
Figure 5: Memory Installation
9
Installations
Advertisement
Table of Contents
