Table of Contents
Advertisement
IDE Primary/Secondary Master/Slave UDMA:
Ultra DMA/33 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver (Windows
95 OSR2 or a third-party IDE bus master driver). If your hard drive and
your system software both support Ultra DMA/33, select "Auto" to enable
BIOS support.
The choice: Auto, Disabled.
On-Chip Primary/Secondary PCI IDE:
The integrated peripheral controller contains an IDE interface with support
for two IDE channels.
separately.
The choice: Enabled, Disabled.
Init Display First:
This item allows you to decide to active whether PCI Slot or on-chip VGA
first.
The choice: PCI Slot, Onboard.
IDE HDD Block Mode:
Block mode is also called block transfer, multiple commands, or multiple
sector read/write. If your IDE hard drive supports block mode (most new
drives do), select Enabled for automatic detection of the optimal number of
block read/writes per sector the drive can support.
The choice: Enabled, Disabled
KBC Input Clock:
This item allows you to adjust the keyboard input clock.
The choice: 8MHz, 12MHz.
Power On Function:
You can use this item to select operating Power On the system.
The choice: Button Only
KB Power ON Password:
You can use this item to limit operating KB Power On system.
The choice: Enter
Hot Key Power ON:
You can use this item to select operating Hot Key to Power On system.
The choice: Ctrl-F1
Select "Enabled" to activate each channel
45
Award BIOS Setup
Advertisement
Table of Contents
