Table of Contents
Advertisement
Award BIOS Setup
Onboard FDC Controller:
Select "Enabled" if your system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install and-in FDC or
the system has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2:
Select an address and corresponding interrupt for the first and second
serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled and
UART Mode Select:
This item allows you to select UART mode.
The choice: IrDA, ASKIR and Normal.
RxD, TxD Active:
This item allows you to determine the active of RxD, TxD.
The Choice: "Hi, Hi", "Lo, Lo", "Lo, Hi" and "Hi, Lo".
IR Transmission delay:
This item allows you to enable/disable IR transmission delay.
The choice: Enabled, Disabled.
UR2 Duplex Mode:
This item allows you to select the IR half/full duplex function.
The choice: Half, Full.
Use IR Pins:
This item allows you to select IR transmission routes, one is RxD2m, TxD2
(COM Port) and the other is IR-Rx2Tx2.
The choice: IR-Rx2Tx2, RxD2 and TxD2.
Onboard Parallel Port:
This item allows you to determine access onboard parallel port controller
with which I/O address.
The choice: 3BC/IRQ7, 378/IRQ7, 278/IRQ5 and Disabled.
Auto.
46
Advertisement
Table of Contents
