Control Panel - Supermicro SuperServer 510T-ML User Manual

Control Panel

Power switches and status LEDs are located on the control panel on the front of the chassis.
Information LED
Feature Description
Information LED Alerts operator to several states, as noted in the table below
NIC2 LED Indicates network activity on LAN port 2 when flashing
NIC1 LED Indicates network activity on LAN port 1 when flashing
HDD LED Indicates hard drive activity when flashing
Indicates power is being supplied to the system power supply; illuminated when the system is
Power LED
operating normally
Reset Button Reboots the system
Power Button Applies or removes power from the power supply to the server; standby power is maintained
Status
Continuously on and red
Blinking red (1Hz)
Blinking red (0.25Hz)
Solid blue
Blinking blue
NIC2
LED
Power
NIC1 HDD
LED
LED LED
Figure 1-2. Control Panel
Control Panel Features
Information LED
Description
An overheat condition has occurred.
(This may be caused by cable congestion.)
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power supply.
UID has been activated locally to locate the server in a
rack environment.
UID has been activated using IPMI to locate the server in
a rack environment.
10
Chapter 1: Introduction
Power Button
Reset Button