Configuration (Dmx); Personality And Starting Address; D-Fi Usb Connectivity; D-Fi Usb Compatibility - Chauvet DJ LED SHADOW 2 ILS User Manual

Table of Contents

Advertisement

Operation

Configuration (DMX)

The LED Shadow 2 ILS works with a DMX controller. Information about DMX is in the CHAUVET DMX
Primer, which is available from the Chauvet website chauvetlighting.com/downloads/DMX_Primer_rev05_WO.pdf.

Personality and Starting Address

The LED Shadow 2 ILS uses up to 4 DMX channels in the 4Ch mode, which defines the highest
configurable address to 509.
When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If the starting address is set too high, access to some channels could be restricted.
For information about the DMX protocol, download the DMX Primer from www.chauvetdj.com.
To select the personality and starting address, do the following:
1. Press <MENU> repeatedly until 4Ch shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the starting address, from d 1–509.
4. Press <ENTER>.

D-Fi USB Connectivity

The LED Shadow 2 ILS is able to become a D-Fi wireless receiver/transmitter with the use of the D-Fi USB
from Chauvet DJ. Simply set the product's DMX Personality and DMX Address, set the DIP switch
D-Fi receiving/transmitting channel, then plug it into the D-Fi USB port.
WARNING! DO NOT plug anything other than a D-Fi USB into the USB port. Doing so may
cause damage to the product.
Once plugged in, the D-Fi USB will take over the product. Wired DMX and manual display
control / menu buttons will be unavailable until the D-Fi USB is unplugged. The priority
levels are:
1. D-Fi USB
2. Wired DMX
3. Manual Digital Display/Menu Buttons

D-Fi USB Compatibility

The D-Fi USB can receive a DMX signal from the D-Fi Hub, the FlareCON Air 2, and other D-Fi USB
products.

Configuration (D-Fi USB)

1. Set the DMX Personality and DMX address on the LED Shadow 2 ILS.
2. Use the Chart provided to set BOTH:
the Channel, and then
The Receiving or Transmitting option
NOTE: DIP Switch 5 is for Transmitting OR Receiving, please choose carefully.

D-Fi USB DIP Switch Channels

Receiving
Ch. 1
2
3
4 T/R Ch. 1
1
2
3
4
5
6
7
8
LED Shadow 2 ILS User Manual Rev. 1
Receiving
2
3
4 T/R Ch. 1
9
10
11
12
13
14
15
16
Transmitting
2
3
4 T/R Ch. 1
1
2
3
4
5
6
7
8
Transmitting
2
3
4 T/R
9
10
11
12
13
14
15
16
Page 7 of 15

Advertisement

Table of Contents
loading

Table of Contents