Table of Contents
Advertisement
3. Setup
AC Power
The LED Shadow 2 ILS has an auto-ranging power supply and it can work with an input voltage range of
100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
•
Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
Fuse Replacement
1.
Disconnect the product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove the blown fuse.
4.
Replace with a fuse of the same type and rating.
5.
Screw the fuse holder cap back in place and reconnect power.
Disconnect the product from the power outlet before replacing the fuse.
Power-Linking
The product provides power linking via the outlet located in the back of the product. See the diagram below
for further explanation.
Power-Linking Diagram
Power
source
It is possible to power link up to 11 LED Shadow 2 ILS products on 120 VAC or up to 20 LED
Shadow 2 ILS products on 230 VAC.
The power-linking diagram corresponds to the North American version of the product ONLY!
If using the product in other markets, consult with the local Chauvet distributor as power-
linking connectors and requirements may differ by country or region.
Page 4 of 15
st
1
product
nd
rd
2
product
3
product
LED Shadow 2 ILS User Manual Rev. 1
Setup
Additional
products
Advertisement
Table of Contents
