Install An Internal Cff Adapter - Lenovo ThinkSystem SR650 V2 Maintenance Manual

If you are instructed to return the defective component, follow all packaging instructions and use any
packaging materials that are provided.

Install an internal CFF adapter

Use this information to install an internal customer form factor (CFF) adapter, such as the RAID 940-16i
internal adapter, 440-16i internal HBA adapter, and 48-port internal expander.
About this task
Attention:
• Read "Installation Guidelines" on page 185 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku:
https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Step 1. Touch the static-protective package that contains the adapter to any unpainted surface on the
outside of the server. Then, take the adapter out of the package and place it on a static-protective
surface.
Note: The adapter is shipped with and preinstalled on a mounting bracket, check and ensure that
the adapter is fixed in place. If there are any loosen screws, tighten the screws using a No.1 Phillips
torque screwdriver. The maximum torque value is 4.8 ± 0.5 inch-pounds.
Step 2. Align the notches on the mounting bracket with the pins on the chassis, place down the adapter,
and slightly slide it as shown to secure it on the chassis.
Figure 184. Internal CFF adapter installation
Step 3. Connect cables to the adapter. See Chapter 3 "Internal cable routing" on page 71.
After you finish
.
Chapter 4 Hardware replacement procedures
239