Install A Rearwall Bracket - Lenovo ThinkSystem SR650 V2 Maintenance Manual

Install a rearwall bracket

Use this information to install a rearwall bracket.
About this task
Attention:
• Read "Installation Guidelines" on page 185 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku:
https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Step 1. Touch the static-protective package that contains the new component to any unpainted surface on
the outside of the server. Then, take the new component of the package and place it on a static-
protective surface.
Step 2. Install the rearwall brackets.
a. Align the rearwall bracket with the chassis rearwall, and insert the bracket into place.
b. Install the screws to secure the rearwall bracket.
Note: The illustrations show installing the A1, B1, and C1 rearwall brackets. The procedure is the
same for installing other rearwall brackets.
Figure 254. A1 rearwall bracket installation (left)
.
Chapter 4 Hardware replacement procedures
327