Install A Super Capacitor On The Chassis - Lenovo ThinkSystem SR650 V2 Maintenance Manual

Install a super capacitor on the chassis

Use this information to install a super capacitor module on the chassis.
About this task
Attention:
• Read "Installation Guidelines" on page 185 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku:
https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Step 1. Touch the static-protective package that contains the new RAID super capacitor module to any
unpainted surface on the outside of the server. Then, take the new RAID super capacitor module
out of the package and place it on a static-protective surface.
Step 2. Install the super capacitor holder.
Figure 244. Super capacitor holder installation
a. Align the notch on the super capacitor holder with the pin on the chassis.
b. Pivot the super capacitor holder inward until the other side clicks into place.
ThinkSystem SR650 V2Maintenance Manual
316