Install A Super Capacitor Module On The Air; Baffle - Lenovo ThinkSystem SR650 V2 Maintenance Manual

If you are instructed to return the defective component, follow all packaging instructions and use any
packaging materials that are provided.
Install a super capacitor module on the air baffle
Use this information to install a super capacitor module on the air baffle.
About this task
Attention:
• Read "Installation Guidelines" on page 185 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DqVplE36HIvdM_sq_Auw3U
• Youku:
https://list.youku.com/albumlist/show/id_59643657.html
Procedure
Step 1. Touch the static-protective package that contains the new RAID super capacitor module to any
unpainted surface on the outside of the server. Then, take the new RAID super capacitor module
out of the package and place it on a static-protective surface.
Step 2. Install the super capacitor module.
Figure 247. Super capacitor installation on the air baffle
a. Open the retention clip on the holder.
b. Put a super capacitor module into the holder.
c. Press it down to secure it into the holder.
Step 3. Connect the super capacitor module to an adapter with the extension cable that comes with the
super capacitor module. See "RAID super capacitor modules" on page 80.
After you finish
Complete the parts replacement. See "Complete the parts replacement" on page 381
.
Chapter 4 Hardware replacement procedures
319