Replacing The Media Converter Slide-In-Modules - Transition Networks PointSystem CPSMC1900-100 User Manual

2.1.4

Replacing the Media Converter Slide-in-Modules

CAUTION: Wear a grounding device and observe electrostatic discharge precau-
tions when replacing media converter slide-in-module(s).
caution could result in damage to, and subsequent failure of, the media converter
slide-in-module(s).
NOTE: The media converter slide-in-modules can be hot-swapped.
To replace a media converter slide-in-module in the CPSMC19xx-100 chassis:
1. Remove the slide-in-module to be replaced by loosening the panel fastener
2. Align the replacement slide-in-module with the chassis installation slot so that
3. Carefully slide the replacement slide-in-module into the installation slot, while
4. Push in and rotate the attached panel fastener screw clockwise to secure the
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
screw that secures the module to the chassis front. Slide the module from the
chassis.
PWR
PWR
TX PWR
PWR LKS LKS
LKF
RXF LKM LKM
RX LNK
RXC LKC TX
TX
TX
RESET
LKF
RXF
RX RX
RX PWR
RXC TX LKC TX
TX
RX RX
CETTF100 CFMFF100 CFMFF100
RX
the panel fastener screw is at the top.
aligning the module's circuit board with the installation guides.
NOTE: Ensure that the slide-in-module is firmly seated inside the chassis.
module to the chassis.
CPSMC19xx-100 PointSystem ™ Chassis
Failure to observe this
PWR PWR
PWR PWR
LA LKS SPD PWR LKS LA
LNK LNK
RXF LKM FRX FLNK LKM RXF
CRX CLNK
RXC COL RXC COL
TX TX
Link Alert Link Alert
E D E D
TX
RX RX
TX RX TX
0 50½ 0 50½
RX RX
CFMFF100
CECF100 CFMFF100 CFETF110 CETCF100
Panel Fastener Screw
PWR
LKS SPD PWR
LKM FRX FLNK
CRX CLNK
TX
TX
RX
RX
TX
RX
CFMFF100 CFETF100
9