Bgp - NetModule NB3710 User Manual

5.4.8. BGP

The BGP tab allows to set up peerings of the NetModule router with other Border
Gateway Protocol enabled routers.
Parameter
BGP status
AS number
Redistribute connected
routes
Redistribute local routes Redistribute routes from the NetModule router's own rout-
Redistribute OSPF
routes
Disable BGP when
VRRP slave
The neighbors tab is used to configure all the BGP routers to peer with.
Parameter
IP address
As number
Password
Multihop
The Networks tab allows to add IP network prefixes that shall be distributed via BGP
in addition to the networks that are redistributed from other sources as defined on the
general tab.
Parameter
Prefix
Prefix length
NB3710 User Manual 4.0
BGP General Settings
Specifies whether the BGP routing protocol is active
The number of the autonomous system to which the Net-
Module router belongs (1-4294967295)
Redistribute routes to networks which are directly con-
nected to the NetModule router
ing table
Redistribute routes learned via the OSPF routing protocol
Disables the BGP protocol when the router is set to slave
mode by the VRRP redundancy protocol
BGP Neighbors
IP address of the peer router
Autonomous system number of the peer router (1-
4294967295)
Password for authentication with the peer router. If left
blank authentication is disabled.
Allow multiple hops between this router and the peer router
instead of requiring the peer to be directly connected.
BGP Networks
Prefix of the network to be distributed
Length of the prefix to be distributed