Voice Gateway Routing Configuration - NetModule NB3710 User Manual

Voice Routing
This page can be used to configure generic voice routing between the endpoints.
Figure 5.51.: Voice Gateway Routing Configuration
Enhanced routing facilities are provided via the SDK interface which is able to dispatch
voice calls based on their attributes (such as phone numer) and other system related
status information (e.g. number/duration of calls per endpoint, registration status and
so on). Using the SDK, you can also initiate or accept a call, adjust its volume level or
do a hangup
Anyway, for simple scenarios the generic method should be sufficient and can be config-
ured as follows:
Parameter
Source
Mode
Destination
NB3710 User Manual 4.0
Voice Gateway Routing Settings
Specifies the source endpoint (i.e. where the call comes in)
The type of action which shall be applied for the call: DROP
will silently hangup the call, ROUTE will route the call to
the specified endpoint.
Specfies the target endpoint (i.e. where to call is routed to)