Table of Contents
Advertisement
Test method
1 Enable the path that routes the time base signal to the trigger output
2 Using the 53132A, measure the frequency of the signal at the trigger output
– This test can be configured manually via the command
NOTE
– This test can also be configured manually via the front panel; access the
– No adjustment is available for this test if it fails (see
Keysight N1911A/1912A Service Guide
connector.
connector.
SERV:BIST:TBAS:STAT ON, which enables the 10 MHz feed to the trigger
output connector (refer to the programming guide for further details on the
use of this command).
Service menu, select Self Test, and select Time Base to enable the 10 MHz
feed to the trigger output connector.
"Troubleshooting
Guide").
Performance Tests
Chapter 4,
2
29
Advertisement
Table of Contents
