Table of Contents
Advertisement
Default Sequence symbol programs the scan engine to the Universal values,
shown below. These are the defaults. Be certain you want to delete or clear all for-
mats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you'll need to know the code I.D., code
length, and character match(es) your application requires. Use the Alphanumeric
symbols (inside back cover) to read these options. You must hold the trigger while
reading each bar code in the sequence.
To Add an Output Sequence
1. Scan the Enter Sequence symbol (see
2. Code I.D.
3. Length
4. Character Match Sequences
5. End Output Sequence Editor
Other Programming Selections
•
HF52X Fix Mount Barcode Scanner User Guide
On the
Symbology Charts
to apply the output sequence format. Locate the Hex value for that symbology
and scan the 2 digit hex value from the Programming Chart (inside back cover).
Specify what length (up to 9999 characters) of data output will be acceptable
for this symbology. Scan the four digit data length from the Programming
Chart. (Note: 50 characters is entered as 0050. 9999 is a universal number,
indicating all lengths.) When calculating the length, you must count any
programmed prefixes, suffixes, or formatted characters as part of the length
(unless using 9999).
On the
ASCII Conversion Chart (Code Page
that represents the character(s) you want to match. Use the Programming
Chart to read the alphanumeric combination that represents the ASCII
characters. (99 is the Universal number, indicating all characters.)
Scan F F to enter an Output Sequence for an additional symbology, or Save to
save your entries.
Discard
This exits without saving any Output Sequence changes.
Require Output
on page 209, find the symbology to which you want
1252), page 212, find the Hex value
Sequence, page 50).
47
Advertisement
Table of Contents
