the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the Telepen Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the
Save bar code. Default = 0.
UPC-A
<Default All UPC-A Settings>
UPC-A On/Off
Note: To convert UPC-A bar codes to EAN-13, see
UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted
at the end of the scanned data or not. Default = On.
104
* On
* On
Programming
Telepen Redundancy
Convert UPC-A to EAN-13
HF52X Fix Mount Barcode Scanner User Guide
Chart. Then scan the
Off
on page 111.
Off