Table of Contents
Advertisement
ENGINE STORAGE (NOT INSTALLED)
-
If the engine is not to be used for long periods, check the storage environment, the type of packaging and make sure these conditions will allow proper maintenance. If necessary,
cover the engine with protective sheeting.
-
Do not store the engine directly on the ground, in damp environments, in areas exposed to the elements, near sources of danger, including less visible hazards such as high-voltage
power lines, etc.
ENGINE STORAGE (INSTALLED)
If an installed engine is not to be used for long periods, it is necessary to carry out a number of maintenance procedures in order to preserve its level of efficiency and protect its
components.
If an installed engine is to be inactive for short periods, carry out the following:
-
Check the electrical contacts and, if necessary, protect them using an anti-rust spray.
-
Disconnect the battery.
-
Empty the fuel tank to prevent the risk of fire.
-
Remove the key from the dashboard and put it in a safe place to avoid acts of vandalism.
-
Lock the cabin and the cowls to prevent strangers gaining access.
If the engine is not to be used for more than 1 month, it is necessary to apply protective measures that are valid for 6 months (see "Protective treatment").
If, after the first 6 months, the engine is still not to be used, it is necessary to carry out further measures to extend the protection period (see "Protective
treatment").
PROTECTIVE TREATMENT
1 -
Check that the engine oil and coolant are up to level.
2 -
Run the engine at minimum idle speed for 15 minutes.
3 -
Switch off the engine.
4 -
Remove the lubrication oil.
5 -
Fill the sump with protective oil: AGIP RUSTIA.
6 -
Start the engine and check for fuel and oil leaks.
7 -
Bring the engine to ¾ of the maximum speed for 5-10 minutes.
8 -
Switch off the engine.
9 -
Empty the fuel tank completely.
10 - Replace the fuel filter.
11 - Spray SAE 10W oil on the exhaust and intake manifolds.
12 - Close all openings to prevent foreign bodies from entering.
13 - Thoroughly clean all external parts of the engine using suitable products.
14 - Treat non-painted parts with protective products (AGIP RUSTIA 100/F).
15 - Loosen the alternator/fan belt.
16 - If necessary, cover the engine with protective sheeting.
After a year of engine inactivity, the coolant loses its properties and must be replaced.
96
Advertisement
Table of Contents
