Lamp Unit Replacement - Marantz VP-10S1 User Manual

❖
Resetting the Lamp Life Counter
The lamp lasts a maximum of 1,500 hours. The projector is
designed to shut off power if the lamp is used beyond this
1,500 hours. In such case, replace the lamp and reset the lamp
life counter as follows.
1. After the "Lamp Life 0 Hours" message appears on the
screen, power to the projector shuts off. Promptly replace
the lamp with a new one. (See "Lamp Unit Replacement"
pg. 36.)
2. After replacing the lamp, press either the POWER button
on the projector or the POWER ON button on the remote
controller.
The below message will appear on the screen for about
120 seconds.
New Lamp ?
Yes
1
3.
Select "Yes" using the
4. Press the ENTER button to reset the lamp life counter.
4
ENTER
3
STANDBY
PATTERN
MENU
ENTER
36
No
2
and buttons.
STANDBY ON
PATTERN INPUT MENU POWER
2
POWER ON
2.
PATT.
V-MUTE
4.
3.

Lamp Unit Replacement

Note:
• The lamp is very hot while lit and shortly after being turned
off. Do not touch the lamp or lamp unit while hot. Wait at
least 1 hour for the lamp to cool down before handling it.
• Do not loosen any screws except those specifically
mentioned in the below procedure.
• The lamp may break under excessive force or mechanical
shock.
• Use only the Marantz original lamp unit LU10VPS1 (sold
separately).
❖
How to Replace the Lamp
Preparation:
Turn off power to the projector before replacing the lamp.
After the cooling fan stops, unplug the AC power cable
and wait at least 1 hour for the lamp to cool down. Then,
replace it.
1.
Press the STANDBY button on the remote controller or
the POWER button on the projector to shut off power to
the projector.
2.
After the cooling fan stops, set the ON/OFF switch in the
OFF position and unplug the AC power cable.
3. Wait at least 1 hour for the projector to cool down
sufficiently.
4. Locate the lamp cover on the projector rear (see below).
Read the caution and warning labels on the cover.
Lamp cover
CAUTION CAUTION HOT ランプ交換は、電源プラグをコン
HIGH-PRESSURE LAMP MAY EXPLODE IF IMPROPERLY UNPLUG THE POWER CORD AND WAIT 60 セントから抜いて60分待ってから
HANDLED. REFER SERVICING TO QUALIFIED SERVICE MINUTES BEFORE CHANGING THE LAMP. 行ってください。
PERSONNEL. 高 温 注 意
ATTENTION ATTENTION CHAUD
LA LAMPE SOUS HAUTE PRESSION PEUT EXPLOSER DEBRANCER LE CORD ON D'ALIMENTION ET
SI ELLE, N'EST PAS MANIPULEE CORRECTEMENT, ATENDER 60 MINUTES AVANT DE CHANGER
CONFIER L'OPERATION A UN PERSONNEL D'ENTRETIEN
QUALIFIE. LAMPE. 警 告
VORSICHT WARNUNG HEISS 高圧ランプは誤った扱いをすると
破裂する恐れがあります。万一の
BEI FALSCHER HANDHABUNG KANN DIE ZIEHEN SIE DEN NETZSTECKER AB UND
HOCHDRUCKLAMPE EXPLODIEREN UBERLASSEN SIE WARTEN SIE 60 MINUTEN BEVOR SIE DIE 際はサービスマンに依頼をしてく
WARTUNGSARBEITEN NUR FACHPERSONAL. GLUHLAMPE WECHSELN. ださい。
WARNING
CAUTION
THIS COVER IS PROVIDED WITH
CONTAINS MERCURY, INTERLOCK TO REDUCE THE RISK OF
DON'T PUT IN TRASH. EXCESSIVE ULTRAVIOLET RADIATION.
DO NOT DEFEAT ITS PORPOSE OR
RECYCLE OR DISPOSE
AS HAZARDOUS WASTE ATTEMPT TO SERVICE WITHOUT
REMOVING COVER COMPLETELY.
CAUTION
HIGH-PRESSURE LAMP MAY EXPLODE IF IMPROPERLY
HANDLED. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
ATTENTION
LA LAMPE SOUS HAUTE PRESSION PEUT EXPLOSER
SI ELLE, N'EST PAS MANIPULEE CORRECTEMENT,
CONFIER L'OPERATION A UN PERSONNEL D'ENTRETIEN
QUALIFIE.
VORSICHT
BEI FALSCHER HANDHABUNG KANN DIE
HOCHDRUCKLAMPE EXPLODIEREN UBERLASSEN SIE
WARTUNGSARBEITEN NUR FACHPERSONAL.
STANDBY POWER ON
PATTERN
PATT.
MENU V-MUTE
ENTER
VIDEO IN S-VIDEO IN COMPONENT VIDEO IN 1 COMPONENT VIDEO IN 2
Y P /C P /C Y P /C P /C
B B R R B B R R
REMOTE TRIG. LIGHT
RGB IN DVI-D IN RS-232C IN 1
INT. EXT. OFF ON
2
OUT
OFF ON
AC IN
∼
ＭＯＤＥＬ ＮＯ．ＶＰ１０Ｓ１／Ｕ１Ｍ
ＡＣ１２０Ｖ∼ ６０Ｈｚ Ｘ．ＸＡ
ＡＵＤＩＯ／ＶＩＤＥＯ ＡＰＰＡＲＡＴＵＳ SERIAL NO.
３６ＶＢ
MARANTZ VP10S1/UIM
ＭＡＤＥ ＩＮ ＪＡＰＡＮ
Tested To Comply
With FCC Standards ＦＡＢＲＩＱＵＥ ＡＵ ＪＡＰＯＮ
FOR HOME OR OFFICE USE Always ground the equipment
Jorda alltid utrustningen
Jordforbind altid udstyret
Ｎｏ．４３００
CAUTION HOT
ラン
セン
UNPLUG THE POWER CORD AND WAIT 60
行っ
MINUTES BEFORE CHANGING THE LAMP.
ATTENTION CHAUD
DEBRANCER LE CORD ON D'ALIMENTION ET
ATENDER 60 MINUTES AVANT DE CHANGER
LAMPE.
WARNUNG HEISS 高圧
破裂
ZIEHEN SIE DEN NETZSTECKER AB UND
際は
WARTEN SIE 60 MINUTEN BEVOR SIE DIE
ださ
GLUHLAMPE WECHSELN.