Lamp Replacement Precautions; Lens Changes - Marantz VP-10S1 User Manual

Lamp Replacement Precautions

• Replacing the lamp runs the risk of burns and electric
shock, therefore shut off power supply, unplug the AC
power cable from its electrical outlet and wait at least 60 min
for the lamp to cool down before attempting to replace it.
• If the lamp breaks, contact your nearest Marantz Authorized
Dealer or Service Center.
CAUTION CAUTION HOT ランプ交換は、電源プラグをコン
セントから抜いて60分待ってから
HIGH-PRESSURE LAMP MAY EXPLODE IF IMPROPERLY UNPLUG THE POWER CORD AND WAIT 60
HANDLED. REFER SERVICING TO QUALIFIED SERVICE MINUTES BEFORE CHANGING THE LAMP. 行ってください。
PERSONNEL. 高 温 注 意
ATTENTION ATTENTION CHAUD
LA LAMPE SOUS HAUTE PRESSION PEUT EXPLOSER DEBRANCER LE CORD ON D'ALIMENTION ET
SI ELLE, N'EST PAS MANIPULEE CORRECTEMENT, ATENDER 60 MINUTES AVANT DE CHANGER
CONFIER L'OPERATION A UN PERSONNEL D'ENTRETIEN
LAMPE.
QUALIFIE. 警 告
VORSICHT WARNUNG HEISS
高圧ランプは誤った扱いをすると
破裂する恐れがあります。万一の
BEI FALSCHER HANDHABUNG KANN DIE ZIEHEN SIE DEN NETZSTECKER AB UND
HOCHDRUCKLAMPE EXPLODIEREN UBERLASSEN SIE WARTEN SIE 60 MINUTEN BEVOR SIE DIE 際はサービスマンに依頼をしてく
ださい。
WARTUNGSARBEITEN NUR FACHPERSONAL. GLUHLAMPE WECHSELN.
WARNING
CAUTION
THIS COVER IS PROVIDED WITH
CONTAINS MERCURY, INTERLOCK TO REDUCE THE RISK OF
DON'T PUT IN TRASH. EXCESSIVE ULTRAVIOLET RADIATION.
RECYCLE OR DISPOSE DO NOT DEFEAT ITS PORPOSE OR
ATTEMPT TO SERVICE WITHOUT
AS HAZARDOUS WASTE
REMOVING COVER COMPLETELY.
CAUTION
HIGH-PRESSURE LAMP MAY EXPLODE IF IMPROPERLY
HANDLED. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
ATTENTION
LA LAMPE SOUS HAUTE PRESSION PEUT EXPLOSER
SI ELLE, N'EST PAS MANIPULEE CORRECTEMENT,
CONFIER L'OPERATION A UN PERSONNEL D'ENTRETIEN
QUALIFIE.
VORSICHT
BEI FALSCHER HANDHABUNG KANN DIE
HOCHDRUCKLAMPE EXPLODIEREN UBERLASSEN SIE
WARTUNGSARBEITEN NUR FACHPERSONAL.
• Before replacing the lamp, read carefully "Lamp Handling
Precautions" ( pg. iii) and "Lamp Unit Replacement"
( pg. 36). Replace the lamp as explained therein.
Note: Pixel defects
DMD TM (Digital Micromirror Device
advanced technologies for consumer products. The DMD
made by high precision technology, however some pixel
defects may be found on the projected image. We are
trying our best to control the quality in order to reduce the
number of defective pixels. It is almost impossible to have
zero pixel defects, even using the most advanced
technology. This is not a problem only for Marantz, but all
DLP TM projector manufactures. Therefore we have to note
that the warranty does not cover the DMD
defects. We appreciate your understandings.
VIDEO IN S-VIDEO IN COMPONENT VIDEO IN 1 COMPONENT VIDEO IN 2
Y P /C P /C Y P /C P /C
B B R R B B R R
REMOTE TRIG. LIGHT
RGB IN DVI-D IN RS-232C IN 1
INT. EXT. OFF ON
OUT 2
OFF ON
AC IN
∼
ＭＯＤＥＬ ＮＯ．ＶＰ１０Ｓ１／Ｕ１Ｍ
ＡＣ１２０Ｖ∼ ６０Ｈｚ Ｘ．ＸＡ
ＡＵＤＩＯ／ＶＩＤＥＯ ＡＰＰＡＲＡＴＵＳ SERIAL NO.
３６ＶＢ
MARANTZ VP10S1/UIM
ＭＡＤＥ ＩＮ ＪＡＰＡＮ
Tested To Comply
With FCC Standards ＦＡＢＲＩＱＵＥ ＡＵ ＪＡＰＯＮ
FOR HOME OR OFFICE USE Always ground the equipment
Jorda alltid utrustningen
Jordforbind altid udstyret
Ｎｏ．４３００
CAUTION HOT
ラン
セン
UNPLUG THE POWER CORD AND WAIT 60
行っ
MINUTES BEFORE CHANGING THE LAMP.
ATTENTION CHAUD
DEBRANCER LE CORD ON D'ALIMENTION ET
ATENDER 60 MINUTES AVANT DE CHANGER
LAMPE.
WARNUNG HEISS
高圧
破裂
ZIEHEN SIE DEN NETZSTECKER AB UND
際は
WARTEN SIE 60 MINUTEN BEVOR SIE DIE
ださ
GLUHLAMPE WECHSELN.
TM ) is one of the most
TM for pixel

Lens Changes

• The lens of this projector can be changed as liked. (LN-
10VP32/LN-10VP40/LN-10VP53) With the right lens, you
can set the projection distance and screen size according
to the environment of use.
Lens
LN10VP32
LN10VP40
LN10VP53
* The above projections distances are given for a
screen with an aspect ratio of 16:9. For screen sizes
and projection distances by lens, see pg. 11-14.
• To change the lens, contact your nearest Marantz
Authorized Dealer or Service Center.
Do not change the lens yourself.
• The lenses used with this projector are as follows.
Projector
(Found on rear panel nameplate)
VP10S1/U1S SHT(32)
VP10S1/U1S STD(40)
VP10S1/U1S LNG(53)
Note: Lamp
P-VIP lamp is one of the most advanced technologies for
TM
consumer products. The lamp made by high precision
technology, however some lamps might be failing before it
reaches its life. And projector's brightness is getting darker
along with accumulated lamp usage hours. We are trying
our best to control the quality in order to reduce lamp
failures. It is almost impossible to have zero failure, even
using the most advanced technology. This is not a problem
only for Marantz, but all projector manufactures. Therefore
we have to note that the warranty does not cover the P-VIP
lamp for lamp failures: explosion, and non-lighting except
initial use. And also we have to note that the warranty does
not cover the P-VIP lamp for lamp failures: flickering, and
getting darker along with accumulated lamp usage hours.
We appreciate your understandings.
Projection distance of 100 inch image
Approx. 125.51 to 156.88 inch
Approx. 159.88 to 209.18 inch
Approx. 209.18 to 313.77 inch
Lens
LN10VP32
LN10VP40
LN10VP53
3