Initial Setting; Activating The Power; Focusing And Zooming - Marantz VP-10S1 User Manual

INITIAL SETTING

Activating the Power

1.
Connect the included AC power cable. (
2.
Set the ON/OFF switch on the projector rear in the on position. The STANDBY indicator on the projector will light up.
3.
Press the POWER ON button on the remote controller or the POWER button on the projector.
The POWER ON indicator on the projector will light up.

Focusing and Zooming

You can adjust the focus and projected image size using the focus pattern.
1.
Press the PATTERN button to project the focus pattern on the screen.
2.
To focus the pattern, press the
Holding the buttons down quickly changes the focus. Adjust the focus so that the focus pattern appears its sharpest, as shown
below.
3.
To adjust the size of the projected image, press the
fine-adjusts the size. Holding the buttons down quickly changes the size.
4. Press the PATTERN button again to cancel the focus pattern. This completes focusing and zooming.
pg. 15)
1 / 2
buttons on the remote controller or projector. Tapping the buttons fine-adjusts the focus.
3 / 4
STANDBY POWER ON
PATTERN
PATT.
MENU V-MUTE
ENTER
STANDBY POWER ON
PATTERN
PATT.
MENU V-MUTE
ENTER
buttons on the remote controller or projector. Tapping the buttons
17