Table of Contents
Advertisement
5.8
Additional information
• Charging cycles and operating times are recorded by
the battery pack itself. For this reason, after replacing
the battery pack, no further steps are necessary to set
up the control module for the new battery pack.
• The drive is always supplied with power from the
battery pack. It is therefore not possible to operate the
drive on the control module without a battery pack.
6
Servicing
6.1
Maintenance
The performance of the ExitSafe battery pack after pro-
longed use or frequent unloading.
For this reason, it should be replaced after two years.
If DIP switch 2 on the control module is set to OFF, a
warning signal will sound after two years of operation or
500 charging cycles of the battery pack. The battery pack
should then be replaced promptly.
The battery pack to be replaced should be depleted
before being replaced by repeatedly actuating the drive.
Charging cycles and operating times are recorded by
the battery pack itself. For this reason, after replacing
the battery pack, no further steps are necessary to set
up the control module for the new battery pack.
elero GmbH
EN | 25
Advertisement
Table of Contents
