Table of Contents
Advertisement
WARNING
The electrical connection may only be conducted by
•
qualifi ed personnel.
Only perform work on the electrical connection if it
•
has been disconnected from the power supply.
Observe the charge status of the battery pack.
•
Note the technical data for the device.
•
Do not extend the original connection cable of the
•
roller shutter drive.
Take care to ensure the connections are correct and
•
secure.
ExitSafe must be installed in a dust-free and dry
environment.
Recommended procedure for the installation and
connection of the ExitSafe in an installation double box
[e.g. electronic fl ush-mounted box ECON 1068-21 or
cavity wall 9062-94 from Kaiser GmbH (www.kaiser-
elektro.de)]:
1. First check whether the ExitSafe components
can be inserted into the installation space without
connecting the cables. Depending on the design of
the installation box, a diff erent sequence may be
appropriate. Please note that the battery pack should
be replaced after 2 years.
2. Connect the required command initiators and control
elements to the eight-pin connection cable that has
not yet been plugged in. Any open ends of lines that
are not being used are to be insulated.
elero GmbH
EN | 19
Advertisement
Table of Contents
