Table of Contents
Advertisement
FichtelBahn
05.3.6 Integration into the control program
Finally, the accessory must be connected to the turnout symbol in the control
program. In the following explanation, this procedure is explained using iTrain as an
example. The procedure is identical to other programs, like RocRail, WinDigiPet or
Modellstellwerk...
Turnout A is set in the "Properties of the turnout" with the following settings:
Function
Description
1
Interface
The BiDiB interface (command station) must be selected here.
2
Node
In the node window, the correct BiDiB module to which the turnout is connected must be selected. If
there are many modules, the displayed UID might help with the selection.
3
Output device
Depending on the control program, different protocols are supported - "Accessory" is required here.
4
Port
The ReadyServoTurn could be used to control 4 turnouts that can be addressed via the accessories 0-3,
for example. This accessory is selected in the port selection menu.
5
Aspect
Our example turnout has 2 aspects in the wizard, each of which has been assigned a macro. If the map-
ping is not correct, the assignment of straight and diverging can also be swapped here.
For turnout B, port 0 is replaced by another value in the properties. e.g. 1 for Acces-
sory 1.
Manual ReadyServoTurn
Manual Version 1.0
Page 26
R
eady
Line
© 2022 FichtelBahn®
Technical changes and errors reserved
Advertisement
Table of Contents
