Table of Contents
Advertisement
FichtelBahn
05.2.2 Servo settings
The following settings for servo 0 are examplary for all 4 servo motors.
The window is part of the wizard, but can also be displayed at any time via the "Servo
ports" tab.
Setting
Servo name
Speed
Trim value bottom and top
Curve form bottom and top
Servo power off
Adjust destination value
Changes to the settings are made locally and are not
yet saved on the module. These changes are only saved
on the module with a click on "Apply". The "Destina-
tion value" function test can only demonstrate the new
changes if they have been saved beforehand. The last
saved values can be read with "Revert".
Manual ReadyServoTurn
Manual Version 1.0
Explanation
Field for entering a user-defined name
Definition of the servo's orbital speed
Definition of the working range of the rotary movement (down = 0% / up = 100%).
Key commands: down = arrow right and left / up = CTRL + arrow right and left)
Servo motion profile: Linear, Soft, Bounce, Rebound, User
The servo is de-energised after reaching the end position.
This function prevents servo hum, but the servo loses its holding force.
The 0% / 100% buttons and the slider can be used to test the servo settings.
Clicking on "Apply" is necessary for the setting to be applied!
Page 14
R
eady
Line
© 2022 FichtelBahn®
Technical changes and errors reserved
Advertisement
Table of Contents
