Multifunction Input With External Power Request Monitor; Multifunction Input With Setpoint Compensation Monitor (A); Multifunction Input With Setpoint Compensation Monitor (B); Digital Contact Enabling Monitor - AERMEC PCO5 User Manual

18.26 MULTIFUNCTION INPUT WITH EXTERNAL POWER
REQUEST MONITOR
Probe 7 con g.
External Demand
Demand Low
Demand High
— Multifunction input enabled with external power request function (MASTER
ONLY )
— Power request corresponding to the minimum size of the input
— Power request corresponding to the maximum size of the input
18.27 MULTIFUNCTION INPUT WITH SETPOINT
COMPENSATION MONITOR (A)
Probe 7 con g.
Ext. Cooling Comp.
Comp. Low
Comp. High
— Multifunction input enabled with setpoint compensation with temperature
probe function (MASTER ONLY)
— Cooling set compensation corresponding to the minimum size of the input
— Cooling set compensation corresponding to the maximum size of the input
18.28 MULTIFUNCTION INPUT WITH SETPOINT
COMPENSATION MONITOR (B)
Probe 7 con g.
Ext. Heating Comp.
Comp. Low
Comp. High
— Multifunction input enabled with setpoint compensation with temperature
probe function (MASTER ONLY)
— Heating set compensation corresponding to the minimum size of the input
— Heating set compensation corresponding to the maximum size of the input
0 %
100 %
07.0 °C
12.0 °C
45.0 °C
50.0 °C
18.29

DIGITAL CONTACT ENABLING MONITOR

Enable Digital
Demand
Power request enabling from digital contacts ID 16, ID 17, ID 18 (MASTER ONLY).
18.30

DIGITAL CONTACT SETTING MONITOR

Digital Demand
Step1
Step2
Step3
Digital contact power step setting (MASTER ONLY):
— Power step 1 ID 16
— Power step 2 ID 17
— Power step 3 ID 18
18.31

PULL DOWN CONTROL ENABLING MONITOR

Pull Down
Temp. Rate
Delay Comp.
Pull Down control enabling (MASTER ONLY):
— Water temperature variation rate below which the activation of new steps is
enabled
— Delay time between the activation of two subsequent steps
N
Step
040 %
075 %
100 %
N
0.1 °C/m
0180 s
37