Overall Intensity Adjustment; Master / Slave Modes; Master Mode - PROEL PLC64TR User Manual

5.1 OVERALL INTENSITY ADJUSTMENT

Turn on the main power before starting your operation. Press and hold down MODE
button until the segment display will show you: d:XXX.
The XXX on the display just means the current overall intensity level and relevant level
can be adjusted within the range of 50% - 100%.
User can select wanted level by pressing the UP or DOWN button, each tap will increase
or decrease relevant level once.

5.2 MASTER / SLAVE MODES

While holding down the MODE button, press simultaneously UP or DOWN buttons, user
can then switch between the SLAVE mode and the MASTER mode availably.

5.2.1 MASTER MODE

Do as the above operation guide says, user can enter the MASTER mode. Then press
the MODE button to switch between MANUAL and AUTO mode.
MANUAL mode
1. Push MODE button to select and enter into MANUAL mode (AUTO/MANUAL led
blinks).
2. In this mode, the output of Channel 1, Channel 2 and Channel 3 (blue, red , green)
can be controlled manually.
3. While holding down MODE button, press UP or DWN buttons simultaneously, user
can enter one of the next submenus: 1:XXX , 2:XXX , 3:XXX.
4. These sebmenus are respectively for the intensity adjustment of channel 1, channel
2 and channel 3 (within the range of 001 – 100). And user can adjust relevant levels
by pressing UP or DOWN button. Each tap will change the level once.
5. Channels and relevant colour lighting control list as below:
Channel 1 : BLUE Channel 2: Red Channel 3 :GREEN
AUTO mode
1. In the same manner as above, press MODE button to enter the AUTO mode
(AUTO/MANUAL led is lit).
2. While holding down MODE button, press UP or DOWN button at one time, user can
enter one of the next submenus: P:XX , SP:XX , F:XXX.
3. These submenus are respectively of Chase program select (1-10 programs & a
sequence of 10 programs available), Chase Speed adjustment (1-99 Chasing rates
available) and Fade Time adjustment (Fade time 0 – 100% available).
4. User can ad just relevant parameter by pressing UP or DOWN button. Each tap will
change relevant level once.
14