Introduction; Purpose Of This Documentation; Scope Of Documentation; Document History - Siemens SITRANS FUS060 Operating Instructions Manual

Introduction

1.1

Purpose of this documentation

These instructions contain all information required to commission and use the device. Read the
instructions carefully prior to installation and commissioning. In order to use the device
correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
1.2

Scope of documentation

For flowmeters based on the FUS060 transmitter various technical literature such as operating
instructions and quick start guides are available on the CD-ROM shipped with the device, or it can
be found on the Internet at www.siemens.com/flowdocumentation
flowdocumentation), where further information on the SITRANS F flowmeter range is also
available.
SITRANS F US sensor and transmitter versions have separate operating instructions.
These Operating Instructions concern only the FUS060 HART transmitter part of the flowmeter
system. The FUS060 PROFIBUS PA transmitter version and SONO 3100, SONO 3300 or SONOKIT
sensors have separate operating instructions.
1.3

Document history

The contents of these instructions are regularly reviewed and corrections are included in
subsequent editions. We welcome all suggestions for improvement.
The following table shows the most important changes in the documentation compared to each
previous edition.
Edition
09/2021
08/2015
SITRANS FUS060 with HART
Operating Instructions, 09/2021, A5E01204521-AL
Remarks
• New firmware
• Minor firmware correction for high flow rates
up 12 m/s
• Cable glands information
• New firmware
• Frontend update
(www.siemens.com/
FW version EDD version
4.00.00-15 4.00.00
4.00.00 4.00.00
1
7