Software Requirements; Configuration Examples - Siemens SIMATIC NET ET 200SP Operating Instructions Manual

Application and functions

1.10 Configuration examples

1.9.2

Software requirements

Configuration software
To configure the entire functionality of the CP firmware version described in this document,
the following configuration tool is required:
● STEP 7 Professional V16
Software for online functions
To use the online functions, the following software is required:
● STEP 7 in the version specified above.
CPU firmware
To use the CP, a CPU 151xSP with a firmware version ≥ V2.0 is required.
1.10 Configuration examples
Below you will find configuration examples for the use of the three CP types.
CP 1542SP-1 - Network separation
The CP is used in the ET 200SP to operate lower-level networks separately or to achieve
separation from the higher-level network.
The ET 200SP can be expanded flexibly with further Ethernet interfaces via the CP. The
network separation allows the setting up of identical machines with the same IP address.
The CP takes over the communication and relieves the CPU.
28
Operating Instructions, 12/2019, C79000-G8976-C426-05
CP 154xSP-1