Connector For The Busadapter - Siemens SIMATIC NET ET 200SP Operating Instructions Manual

Connector X80 is intended for connection to a single or redundant power supply. The power
supply is connected to the CP with the supplied plug-in terminal block. The terminal block is
plugged in to the socket X80 of the CP.
For information on installing and connecting up, refer to the sections Installing the CP
(Page 42) and Connecting the CP (Page 46).
Reverse polarity protection
The plug-in terminal block for connector X80 is designed so that it can only be plugged in in
one position. This provides constructional reverse polarity protection.
The connector X80 also has electronic reverse polarity protection.
You will find further data on the power supply in section Technical specifications (Page 99).
2.3

Connector for the BusAdapter

Operation of the device only with BusAdapter
For connecting to Ethernet the CP requires a BusAdapter. A BusAdapter does not ship with
the CP.
The slot is on the front of the device:
Figure 2-2
You will find the bus adapters supported by the CP in section BusAdapter (Page 109).
For information on installing and connecting up, refer to the sections Installing the CP
(Page 42) and Connecting the CP (Page 46).
You will find the pinout of the Ethernet interface in section BusAdapter (Page 109). You will
find further technical specifications of the bus adapter in the manual /3/ (Page 114).
CP 154xSP-1
Operating Instructions, 12/2019, C79000-G8976-C426-05
Front of the CP, the slot for the bus adapter is marked gray.
LEDs and connectors
2.3 Connector for the BusAdapter
37