Table of Contents
Advertisement
Fit:
•
The two exhaust pipe protections (23) and (28), complete
with internal thermal protections, Fig. A, inserting them into
the silencer.
•
Tighten the two screws (22) Fig. A into the top section.
•
Tighten the two screws (22) into the bottom part, in the
special seats in the licence plate support Fig. B.
Fit:
•
The two exhaust pipe end pieces, right (27) and left (24),
Fig. C.
•
Tighten the six screws (26).
•
Tighten the exhaust pipe protection screws.
NOTE
The two end pieces are not mirrored and therefore, careful as-
sembly is required. Each terminals has its direction marked with
an L (left) or (R), right section.
Fit:
•
The two thermal bulkheads (A) left and right (B), securing
with the relevant screws Fig. D.
EXHAUST PIPE PROTECTION REMOVAL
Removal:
•
carry out the installation steps in reverse order.
All manuals and user guides at all-guides.com
FAIRING
EXHAUST PIPE PROTECTION INSTALLATION
- 157 -
22
23
22
24
26
B
CHAS
22
28
27
26
A
A
B
C
D
Advertisement
Chapters
Table of Contents
