Benelli BN600R 2014 Service Station Manual page 152

Fit:
• The left front footrest plate (4) Fig. A
NOTE
Apply thread locker to each of the fastening screws (6).
• Tighten the two screws (6) with the following torque:
Torque 25 N*m
NOTE
If the left rubber footrest cover (22) is worn, replace it.
Fit:
• The gear control lever (21) on the textured gear of the
engine.
NOTE
Apply special grease to the screw (20) fastening the gear lever
(21).
• Tighten the screw (20) to the following torque:
Torque 8 N*m
Adjust:
• The gear control arm (16) and 210 mm distance between
the ball joints (18) and (14) Fig. A.
NOTE
According to the rider's sensitivity, it is also possible to change
this as needed.
Removal:
• carry out the installation steps in reverse order.
All manuals and user guides at all-guides.com
CYCLING
LEFT FRONT FOOTREST INSTALLATION
CYCLING
LEFT FRONT FOOTREST REMOVAL
- 151 -
CHAS
6
21
210 mm
A
4