Benelli BN600R 2014 Service Station Manual page 242

Fitting:
1. Once each part has been checked, proceed to assemble
the radiator, following the procedure for removal described
above, this time in reverse order.
2. Tighten the fastening screws of the radiator (1**-12**) to the
following torque:
Torque 10 N*m
3. The clips ("clik" 10**) must be replaced each time they are
open.
4. Once the parts are assembled, connect the electrical parts
of the radiator bulb and fan and proceed to fi ll the circuit
Fig.E
NOTE
While fi lling the circuit, pinch the hose as the fl uid is being deliv-
ered to remove any air bubbles.
All manuals and user guides at all-guides.com
RADIATOR
RADIATOR REMOVAL/FITTING
- 241 -
COOL
E