Flywheel Fitting - Benelli BN600R 2014 Service Station Manual

Fitting:
1. Assemble the parts of the whole freewheel (9) and tighten
the 6 fastening screws (11) Fig. A. to the following torque:
Torque 24 N*m
2. Insert the double gear (5), shaft (4) and starter gear (6) Fig.
B
IMPORTANT NOTICE
During the insertion of the fl ywheel, remove the fl ywheel-drive
shaft locking key (x) Fig.C .
3. Insert the fl ywheel (10) Fig. C .
4. Use the specifi c tool (**) to tighten the screw (16*) and the
washer (15*) to the following torque:
Torque 120 N*m
(**) fl ywheel assembly tool
Code:......................
NOTE
The numbers marked (*) are shown in the replacement parts
table in the "Pistons" chapter, "Piston removal" section.
5. Tighten the fastening screw (13*) fastening the plate sup-
port (12*)
6. Tighten the 3 fastening screws (7)
7. Apply the gasket (11*)
If there is any tearing/trace of wear, replace the gasket.
8. Use the specifi c tools (**) to fi t the cover (10*)
(**) tool to remove the fl ywheel cover
Code:......................
9. Tighten the 9 fastening screws (*1) to the following torque:
Torque 12 N*m
Use Loctite thread locker to secure.
10. Assemble the cap (3*) and the relevant gaskets to the left
casing cover (10*) Fig. D.
NOTE
The numbers marked (*) in points (5-7-8-9-10)are shown in the
replacement parts table in the "Starting" chapter, "Phase sensor
installation/adjustment" section.
All manuals and user guides at all-guides.com
STARTING

FLYWHEEL FITTING

- 225 -
6
(**)
1*
10*
ENG
A
11
B
4
5
C
10
D
12*
13*
7
11*