Benelli BN600R 2014 Service Station Manual page 106

Fitting:
Follow the assembly sequence shown below:
WARNING
Before installing, clean all of the internal parts of the brake, and
lubricate them with clean or new brake fl uid.
Never use solvents on the internal parts of the brake.
• Assemble the ball joint (Z) to the brake control lever, tighten
the nut and fastening screw (y) Fig.B to the following torque:
Torque 10 N*m
• Tighten the fastening screws (x) on the brake pump(6) Fig.
A to the following torque:
Torque 10 N*m
• Connect the idrostop (8) and the relevant gaskets (7) to
the rear brake hose (1) and the brake pump. Tighten the
idrostop to the following torque:
Torque 26 N*m
WARNING
To guarantee the safety of the bike, it is essential for the path of
the brake hose to be correct.
All manuals and user guides at all-guides.com
FRONT AND REAR BRAKES
REAR BRAKE PUMP INSTALLATION
- 105 -
CHAS
X
Z
Y
A
B