Advertisement
4.
Attaching
the Side Seal and the
Blade
1)
Clean the surface on which the side
seal will be attached using alcohol.
2)
Attach
the side seal at the position
shown in Figure 4-606.
Attach
Ihe seal so that the long hole
al its end is matched
with the round
hole
of the developing
assembly
housing.
I
I
I
/
Figure 4-606
Figure 4-609
3)
Attach
all
parts
that
have
been
detached except the blade.
,.,.,
Make sure that the gear is assembled
with the longer tooth in the groove.
Figure 4-610
4)
Force
the blade
mount
against
the
developing
assembly
in the direction of
the arrow, and tighten the two screws.
,,_
Figure 4-611
5)
Loosen
the four screws
that hold the
blade on the blade mount, and tighten
them again.
Advertisement
