Advertisement
IV.SETTING THE CT UNIT
3)
1)
Hold both
ends so that the yellow seal
(round) is to the front, and roll it in the
direction of the arrows about ten times
as shown below.
Figure 5-l 6
2)
Take
the CT unit from
the storage
case, and set it in the copier; thereafter,
hold the CT unit in place, and pull the
yellow tab straight out.
l_)rIl
Tab (yellow)
Figure 5-l 7
4)
5)
6)
Put the CT unit back into the storage
case, and roll it about ten times in the
direction of the arrows.
Figure 5-l 8
Shake it in the direction
of the arrows
about ten times.
_.
Figure 5-l 9
Set the CT unit in the copier
once
again,
and make
test copies
in the
DIRECT
mode;
repeat
step 4) if the
image is uneven.
-_
Set the CT unit in the copier, and pull
the orange tab straight out; thereafter,
close the front door.
I
I
Tab (orange)
Figure 5-20
Advertisement
