Advertisement
3)
Slide the grip plate in parallel
to the
body, and adjust the registration
at the
front and rear.
Non-image width
at
rear decreases. while
non-image width
at
front
increases.
Non-image width at
front
decreases,
while non-image
width
at rear in-
'3)
7)
6)
Figure 3-217
4)
Tighten
the four mounting
screws
on
the grip plate after adjustment.
5)
Set the deck.
Make copies using the paper deck.
Repeat steps 3) to 6) if the registration
T-
is outside the standards.
Fix the front
cover
so that
the gap
between
the front cover and pedestal
frame is about 0.5 mm.
0.5 mm
kwJr0x.1
Pedestal frame
tll-
/
Figure 3-218
3-6P
CCWRlGHT@
,093CbMNNC
Advertisement
