Advertisement
5. INSTALLATION-
~ D. Adding Toner
Step
Work
Remarks
1
Remove the door switch actuator.
2
Disengage
the developing
assembly,
and slide it until it stops.
3
Shake the toner cartridge well.
4
Open the developing
assembly lid, and
fit the boss on the rear end of the toner
cartridge into the hole of the plate on
the rear end of the developing
assembly;
thereafter,
pull the toner
cartridge to the front somewhat
so that
it comes into contact with the boss
found on the left side of the front.
5
Hold the toner cartridge, and pull on
the seal to the front until it stops.
6'
Tap lightlb on the top of the toner
cartridge until all toner has'fallen into
the developing
assembly.
7
Remove the toner cartridge, and keep
it in an empty box.
8
Close the developing
assembly lid, and
slide the assembly inside until it stops.
9
Turn the developing
assembly lever
clockwise to engage it.
10
Close the front cover.
11
Set a blank sheet of paper (A3/1 l"xl7")
The operation
causes
the toner insid
on the copyboard
after the COPY
the developing
assembly to be stirred.
START key goes green, and make six
to ten copies.
Advertisement
