Speco O2P25X Quick Start Manual
  1. Manuals
  2. Brands
  3. Speco Manuals
  4. Security Camera
  5. O2P25X
  6. Quick start manual

Speco O2P25X Quick Start Manual

Hide thumbs Also See for O2P25X:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Quick Start Guide
O2P25X

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the O2P25X and is the answer not in the manual?

Questions and answers

Related Manuals for Speco O2P25X

Summary of Contents for Speco O2P25X

  • Page 1 Quick Start Guide O2P25X...
  • Page 2 This owner's manual is designed to be a reference tool for your system. Please read this manual carefully before operating the unit and retain it for future reference. Should you require any technical assistance, contact Speco Technologies Tech Support at 1-800-645-5516 Important Safeguards and Warning 1.
  • Page 3 Technologies reserves the right to modify these without notice and without incurring any obligation. Speco Technologies is not liable for any loss caused by improper operation. Note: Before installation, check the package and make sure that all components are included.
  • Page 4 Overview Overview 1 Ethernet connector Power connector 3 Safety wire Cable Connection...
  • Page 5 ► Connecting Network Cable ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through the both elements. Then crimp the cable with RJ 45 connector. ③ Connect the cable to the water-proof connector. Then tighten the nut and the main cover.
  • Page 6 Micro SD Card Installation Insert a micro SD card 1. Loosen the four screws of 2. Insert a micro SD card as indicated the cover and then remove above and then install the cover back. the cover. Wall Mounting 2. Secure the PTZ camera to the 1.
  • Page 7 3. Drill the screw holes on the wall 4. Insert two screws to the holes according to the drill template. Then as indicated by the arrows (left) insert the plastic plugs into the holes. and leave 12mm clearance. 6. Attach the bracket to the wall 5.
  • Page 8 The camera is set to DHCP by default. ② Install IP Scanner from the CD and run it after installation. 5C:F2:07:24:68:B9 O2P25X ③ In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer.

Table of Contents