4 PTZ Menu Setup
On the PTZ control panel of IE remote preview interface, call Preset 95 and click
menu setup.
The menu setup can be displayed when the resolution of the live is set to 1920×1080.
After you go to the main menu interface, you can select the menu by clicking the direction button (
:To select menu by moving up and down.
:To return to the menu on the left.
:To confirm to enter sub-menu or to select the menu on the right.
Note: Dash (-) before the menu means that the menu is not available. Different models may have different menus. The menus in this
manual are for reference only.
4.1 System Information
Select System Setup by clicking
You can view the software and firmware version, camera, system temperature, date, dome ID, dome protocol and baud rate here.
4.2 System Setup
Select System Setup by clicking
4.2.1 Auto PT Flip
Select Auto PT Flip and then click
selected, please click
button to return to the menu on the left and click
return or exit to the main menu in the following settings are similar to the above-mentioned steps. The following contents will not
introduce it in details).
After you exit the main menu, press and hold
automatically flip.
or
button and then click
or
button and then click
to set up the menu on the right; click
button to let the speed dome move to the bottom. Then the dome will
. This will take you to see the following main
button to go to System Information menu.
button to enter System Setup as shown below:
or
button to select Exit. (The ways to go to sub-menu,
6
).
button to select On/Off. If "On" is